Recent content by Clutch_less

  1. C

    ZF6 cooling needed

    Anybody know what company made a clutch kit (flywheel, pressure plate, disc, etc.) with the part no. pk-hd 1050k ? I found in my records this kit was installed in truck the last time but SBC or Valaire don't list the number as one of theirs. Google hasn't found it for me either. This clutch...
  2. C

    LB7: Broken pedal

    Eric contacted me--thanks- I think I'll be getting his all metal clutch pedal assembly soon:)
  3. C

    LB7: Broken pedal

    Has anyone talked to Eric Haverkamp (sp?) I need one of his metal clutch pedal assemblies and email to him hasn't worked so far. A phone # might be better in this case. Thanks.
  4. C

    ZF6 cooling needed

    Chevy---That BD Diesel kit looks like exactly what I'm looking for. The installation manual says, "This kit is for both automatic and manual transfer case trucks." The latter is me. Thanks for the lead. I'll definitely check it out. :D:D
  5. C

    ZF6 cooling needed

    I've not paid much attention to the part of the truck. But I'll do as you suggest and look for any wiring. My diesel technology drive line guys will know for sure. BTW, my truck is early 02 4WD.
  6. C

    ZF6 cooling needed

    Melms--that's a great suggestion.:thumb: I'll ask the diesel technology guys who do the wrenching on my truck to lower idle for me when they do the clutch work for me next month. How much can the idle be lowered without causing problems when not backing? I'm getting mixed messages about...
  7. C

    ZF6 cooling needed

    I like these suggestions. CL and BD suggest using a circulating pump to move fluid from the tranny to a cooler up front. I'd wire it to a switch so I could cut it off in freezing weather until the tranny heats up. I'll need a temperature gauge for the tranny. I probably don't understand...
  8. C

    ZF6 cooling needed

    Motul 660 sounds like the way to go on the hydraulic fluid. Good for racing and can take the heat!
  9. C

    ZF6 cooling needed

    CL--I'm glad to hear that a dual disc solved your disengagement problem. Do you think that it was a heat build up issue caused by a single disc slipping on you? As I've noted above, I don't believe my single disc clutch is slipping, but a dual like yours should answer any question of slippage...
  10. C

    ZF6 cooling needed

    I was told by the drive line shop in BC that installed the last clutch that it is a South Bend single organic disk. New single mass flywheel and slave were installed too. I agree that it seems hard to me for the transmission would heat up enough to cause the disengagement problem. (There is...
  11. C

    ZF6 cooling needed

    The last 2 clutches were installed with new slave cylinders and single mass flywheels. The clutch friction disc has always been single. Next month I plan to pull the transmission and inspect the clutch parts for signs of what's going on. At that time I also plan to put in a new master cylinder...
  12. C

    ZF6 cooling needed

    I recently started pulling a 6,000 lb boat/trailer combo and my ZF6 is getting a lot hotter than in the past. Hot enough, I believe, to cause clutch disengagement issues after a long day of hauling the boat. My 02 3500 CC is converted to a class C motor home and when fully loaded the gross...
See more
Top Bottom