Recent content by Bdirtymax

  1. B

    Used V2 for sale

    Sorry didn't get the reply. Pp on the way Thanks
  2. B

    Used V2 for sale

    Sent you an email a week ago. You take paypal?
  3. B

    LMM: Fluctuation

    It doesn't fluctuate really. Everything follows commanded and holds. Just notice when looking at the logs it's a bunch of tight oscillations.
  4. B

    LMM: Fluctuation

    Looking to see if I can figure out what is causing the quick oscillation / fluctuation with flow, pulse and even fuel pressure on my truck. Or is it normal? Thanks.
  5. B

    LMM Lambda and Boost

    I'm sure you've looked but torque based fuel cuts a lot of flow in the high alt table compared to low alt. The calc.cylair pid works for me. I have several logs with it on my LMM but I'm low alt.
  6. B

    LMM Lambda and Boost

    If you can find a log showing maf gps at high alt couldn't you use the formula from the calc.cylair pid of {SAE.MAF.gps}*15/{SAE.RPM}? Would be more time consuming then finding a log with the info already but it's a possible option.
  7. B

    LBZ: Tune Check

    Anyone care to check this tune and give me feedback / criticism on it? In my mind I think it would run pretty good. I appreciate anything good or bad. Thanks
  8. B

    LMM: Guestimate

    Thank you :thumb:
  9. B

    LMM: Guestimate

    Just curious if anyone could give me an idea of the power being produced based off Flow, Pulse, Timing, Boost, and FRP numbers from my log? Here's what I have. This is about the average from 2900-3200 RPM RPM 3126 Flow 124.4mm3 Pulse 2540 FRP 195.36mpa Boost 294kpa Timing 23.4* Thanks
  10. B

    Datalogging

    Ask your tuner if they can send you a quick setup and instructions. Otherwise you will need to go into V8 and select your controller and pids and program it into the device.
  11. B

    Engine Mounting Plate

    Looks nice Quinton. Are the bolts going into the block 8x1.25 thread or? Thanks/
  12. B

    Engine Mounting Plate

    Awesome thanks CL!
  13. B

    Engine Mounting Plate

    I know some of you have made adapters to mount the engine sideways in the engine stand. I want to make one for my build coming up. I know guys are using 1/2" plate but can anyone tell me what size that piece should be? Looking to go pick up a piece but I'm not sure what size to get. 6x6 6x8 or...
  14. B

    LMM: 2600 Tune

    A mildly hot tune I put together. Any professional criticism appreciated. Use at own risk. Not the safest for the transmission.
  15. B

    Allison 6sp: Allison 6 speed no reverse

    You'll have to get a scan tool to read the state of the PS4 and IMS or setup the EFIlive Pids to monitor them. With Key On Engine Off, the PS4 should say ON. It's a normally closed switch. If it says off, you have an open in the circuit from the switch to the TCM or the switch is stuck. If...
See more
Top Bottom