Wheel/tire combo with 3" lower

[Ronisonce]

I'm lowering my truck 3 inches and I need some help on what will fit for 20" rims and tires. I was thinking gear Big Block - 726M or fuel mavericks.. 20x10. The tires I am considering are 305/50/20 Nitto 420S or Toyo Proxy ST. Any help or suggestions are very much appreciated. I do NOT like stretched tire look at all and I do not like excessive poke. An inch I can deal with.

 

[whitetrash21]

They'll fit. Just need to do some trimming....nothing to excessive.

 

[Ronisonce]

Maybe i'll just get 285/50/20 then... Any idea which offset is needed? I don't want poke, maybe 1" MAX and I don't want ANY stretch lol.

 

[solidrunner]

My 22x9.5 Fuel Mavericks have a +20 (or +25, can't remember) offset and they are perfectly flush in the front. Had to add a 1.5" spacer in the back to make them flush. Tires are 305/40-22

 

[whitetrash21]

Maybe i'll just get 285/50/20 then... Any idea which offset is needed? I don't want poke, maybe 1" MAX and I don't want ANY stretch lol.

My last truck was dropped an inch or so in the front, 3 in the back. Ran 20x9 XDs with -12 BS....305/50-20 zeons. I had to trim a little off the valance, and trim up the back fender liner about 2". Took all of 20 mins to do. No rubbing after that

 

[whitetrash21]

Sat like this....

 

[Pwinland95]

Where are u located? I have some 20x10 -12 black and milled fuel Mavericks like new

 

[Kunz111]

I have gear big block 726 mb on my lmm lowered 2 in the rear and have the bolts way down in the front. Off set is 0 20x9s with nitto 420 in 305/50/20 and they do rub a little with no trimming.

 

[motoking_1990]

20x10 -44 285/50r20s sticks out a bit more than an inch and had to cut the bumper and the fender mod Corbin wrote. Was going to run 305/50s but they rub too bad.

Sent from my SM-G920V using Tapatalk

 

[motoking_1990]

I also have flares so you would have to account for that as well.

Sent from my SM-G920V using Tapatalk