Water/Meth with PPE hot+2
- Thread starter tylerrustLB7
- Start date
Start psi is 15lbs & full boost at 26lbs, you can't go by the dials on the controller(they numbers are to far apart). The way I did it was hooked up a air line from the shop preset on a regulator to 15lbs, pulled the boost line from my boost gauge using the air gun put it to my line to make sure it was dead on 15lbs, then just set the controller to that, repeat thoes steps for the full boost.
...and that's enough to completely atomize the water?? or is that not the point??
sorry, i dont know jack about water/meth injection. just curious.
sorry, i dont know jack about water/meth injection. just curious.
enough boost? You just want to make you have it all on befor the egt's get to high because the water/meth is just going to slow them down. And you would want full spray when you go through the traps and 26psi at the end no problem.
Wes, the kit M/W systems normally inject at 150-200 psi of injection psi. All comecially avalible kits use the Sur-flo "black" pump so they all run about the same psi's , IMO
Yea my Snow pump is preset from the factory at 150psi, max is 180 with a couple of turns.