upgrades while I install a built tranny and torque converter

[Teamvi]

Anything that I should upgrade while I swap out my old tranny for a built one I got and a 1058 torque converter? Should I upgrade lines? Motor mounts? any braces? tranny mounts? bolts? also what kind of tranny fluid do you recommend?
thanks

 

[Teamvi]

truck is a 2005 lly with normal bolt ons and tuner, will be upgrading from a ats tuner to a efi in the near future. is the stock flexplate ok?

 

[Dozerboy]

What other mods do you have? Maybe a down pipe, or turbo....lol

 

[Hot COCOAL]

Anything that I should upgrade while I swap out my old tranny for a built one I got and a 1058 torque converter? Should I upgrade lines? Motor mounts? any braces? tranny mounts? bolts? A:yes you should also what kind of tranny fluid do you recommend? A:alot of times, different builders call for different fluids
thanks

What other mods do you have? Maybe a down pipe, or turbo....lol

Lol

what modz?....all of the above!
Hahaha

 

[gmduramax]

RDL uppipes and downpipe

 

[Teamvi]

I have a downpipe already

 

[Teamvi]

Got exhaust, intake, tuner, lift pump, race plug, drilled driver side fuel rail fitting, egr delete, etc. goin to possibly go bigger turbo or twins in the future.

 

[andy-stevenson]

Even if you don't do the turbo now or up pipes now. It'd probably be worthwhile to break the bolts loose and pull them and antiseize them. Might save you a headache in the future if you decide to swap the turbo.

 

[Teamvi]

Ok, should i upgrade to a bd flexplate while i am in there or is stock fine if its not cracked, truck has 218k on it, also gonna see if i got any seals leaking

 

[Mike L.]

Ok, should i upgrade to a bd flexplate while i am in there or is stock fine if its not cracked, truck has 218k on it, also gonna see if i got any seals leaking

I would go with a SoCal flex plate. It is the best one out there.

 

[Teamvi]

how durable is the stock one? is a mag hytec deep dish pan any good?

 

[Mike L.]

how durable is the stock one? is a mag hytec deep dish pan any good?

For what?

 

[Teamvi]

How durable is the stock flexplate? Read where some have broke them with little power and some with alot, i m probably not goin over 600 hp for awhile, on stock bottom end

 

[Mike L.]

How durable is the stock flexplate? Read where some have broke them with little power and some with alot, i m probably not goin over 600 hp for awhile, on stock bottom end

My question was about the mag pan.

 

[Teamvi]

Is it a good idea to put one on a built tranny for a daily driver

 

[Awenta]

Spend that money on a cooler or lines that don't leak

Sent from my SM-N910V using Tapatalk