I ordered the repair lines from Alligator for my 07 D/A, but I cant figure out how they mount. They definately don't look like the stock lines. Has anyone replaced these lines that would have suggestions for me?
Trans Cooler Lines
- Thread starter tbj
- Start date
Look at this thread: http://www.dieselplace.com/forum/showthread.php?t=448060&highlight=alligator+lines
I understand they dont send instructions with the lines, but a couple posts in that thread tell which fittings go where.
I understand they dont send instructions with the lines, but a couple posts in that thread tell which fittings go where.
Not to knock what anyone has available but I built my own trans lines for less than $75. I pulled the fittings out of the trans cooler and had my buddy Ryan at Hose Power match them up with some 90° fittings and -8 JIC push lock fittings with 1/2" hose. This allows you to route the lines over and under whatever you want and you dont have to deal with any hard lines. We'll see how well they hold up but I know we have run over 400 psi on the same push lock fittings at over 300° with no failures. Just some food for thought.
Also the new lines clear my exhaust much better than the stock lines.
Also the new lines clear my exhaust much better than the stock lines.
