Stall converter

[cumminsman202]

Ok just rebuilt my trans an I go to drive it an it feels fine for the first 5 to 10 miles then go to take off an it feels like it's slipping never drove a truck with a stall a few buddies say it the stall makeing it feel that way but never had a trans pull good first starting out an then feel like it's slipping after a few miles any help would be great oh an the trans kit is a revmax with a +750 stall with billet stator

 

[Mike L.]

Get codes.

 

[cumminsman202]

Code was P0880 tcm power input signal. Could this cause my fuel system to act up also?

 

[IOWA LLY]

Oh good lord


Sent from my iPhone using Tapatalk Pro

 

[IOWA LLY]

You have to have a "3/4 race cam" to go with a "stall converter".


Sent from my iPhone using Tapatalk Pro

 

[joshd472]

Your screen name fits your grammar perfect.

 

[BrandonLLY]

Would you say the stall occurs at city speeds or closer to highway speeds? very important for us to help you.

 

[cumminsman202]

it doesn’t do it when I first start driving. It happens when I drive for about 15 minutes an it only does it in first gear when I start to take off after that it drives fine. So I’d say city speeds.

 

[Chevy1925]

If you put the truck in drive and hit the throttle while holding the brake what rpm will it go to what does the rpm go to when you hit the gas not on the brake if you turn the tune up enough to blow smoke does it get better what about hammering on it on the freeway you should probably change the fuel filter while your at it the 3/4 race cam isn't a bad suggestion

 

[Burn Down]

If you put the truck in drive and hit the throttle while holding the brake what rpm will it go to what does the rpm go to when you hit the gas not on the brake if you turn the tune up enough to blow smoke does it get better what about hammering on it on the freeway you should probably change the fuel filter while your at it the 3/4 race cam isn't a bad suggestion

Dafuc am I reading???:rubeyes:

 

[Mike L.]

Dafuc am I reading???:rubeyes:

With brake on you're checking stall speed. With brake off you're checking flash.

 

[Burn Down]

With brake on you're checking stall speed. With brake off you're checking flash.

I was admiring his punctuation Mike

 

[Chevy1925]

I asked him once already in a different thread to clean up his craptasric grammar. Doesn't wanna do that but wants help. Well let's have him de-code then

 

[Mike L.]

I was admiring his punctuation Mike

What punctuation?:rofl:

 

[cumminsman202]

I asked him once already in a different thread to clean up his craptasric grammar. Doesn't wanna do that but wants help. Well let's have him de-code then

What do you want de-coded? The code thrown was P0880. What are the most common spots to look at for wire chafing? Or is their anything else I should check?

 

[cumminsman202]

Now I’m throwing a p0872 code I believe it’s the in the wiring. What do you guys think?

 

[Mike L.]

E shift valve is sticking.

 

[cumminsman202]

Could a wiring issues cause this, because I have other issues with the truck also. Being that when I unhook my rail pressure gauge from the sensor an plug the factor please gauge in by itself the truck will die.

 

[Mike L.]

I doubt it very much.

 

[JRein]

E shift valve is sticking.

What Mike said. It's a son of a bitch

Sent from my SAMSUNG-SGH-I747 using Tapatalk