Where you you guys getting shims to adjust the pinion angle after using drop shackles in the rear?
Shims to adjust pinion angle
- Thread starter coker6303
- Start date
any suspension shop/dealer should have these
Did you finally bite the bullet?? We want pix damnit:baby:
Did you finally bite the bullet?? We want pix damnit:baby:
I haven't lowered it yet but I'm just trying to make sure I have everything here when I start. I know raising the rear of the leaf connection is going to tilt the pinion down and increase the angle some, maybe it won't be that bad.
Hopefully I can get a free weekend to start and finish this project. Wanted to do it last weekend but had family in town. Headed out with a trailer load of fourwheelers this Friday so this weekend is shot too. Looks like it might be November before I can knock it out.
Sent from my ADR6400L using Tapatalk
Hopefully I can get a free weekend to start and finish this project. Wanted to do it last weekend but had family in town. Headed out with a trailer load of fourwheelers this Friday so this weekend is shot too. Looks like it might be November before I can knock it out.
Sent from my ADR6400L using Tapatalk
I don't have any shims in mine either and it's got 2" shackles. What's the benefit of the shim? My truck doesn't vibrate or eat u joints.
Sint frum tha orijinul smert fone
Sint frum tha orijinul smert fone
I didn't use any shims with 3" drop shackles.
They only take thirty minutes to install.
