s475 compound with s366

[dirtylb7]

What's you're Guy's inputs On a s475/s366 compound twin set up
what HP would I see in a set up like this with stock pump and 40 overs?

 

[dirtylb7]

Anyone? Looking to order s366 ASAP any help guys already have the 475

 

[SickLL7Crenshaw]

The s475/stock setup will push your stock motor beyond its limits with more fuel. What HP are you looking for to add the 66?

Sent from my B15 using Tapatalk

 

[TLyons90]

Most guys I believe go with a s366/s480 setup. I haven't seen many at all or read up on s475 over s366 setups however I would say it should spool up a little quicker and if you ever want to go bigger it won't be a problem!

 

[dirtylb7]

I was also thinking spool up might be a lil quicker. I know they use a 480 mostly but I have an s475 already so figured I'd put it to use in a twin set with a 66. Just wanna make sure the 75 wont be to small for the 366

 

[TLyons90]

I was also thinking spool up might be a lil quicker. I know they use a 480 mostly but I have an s475 already so figured I'd put it to use in a twin set with a 66. Just wanna make sure the 75 wont be to small for the 366

I wanna say you should be perfectly fine but not 100% sure. Hopefully someone with a bit more knowledge will chime in!

 

[DIESELMAFIAPER.LB7]

that a little close in size for
me but it can be done

 

[coker6303]

Is your 475 you already have a t4 or t6?

 

[dmax711]

I'd think about turning that 75 into a 480..

 

[MAXX IT OUT]

I was looking at doing it, but I think the exhaust housing are the same, so it wasn't spool any faster than a s480 and move less air....

 

[dirtylb7]

Is your 475 you already have a t4 or t6?

It's a t6.

 

[02ilduramax]

I am doing the same set up on my repower

 

[dirtylb7]

Has anyone ran this setup yet? I'm thinking ill have the 75 turned into an 80 in a few months just gonna run my 75 until then just really looking for ppl who have done this to see how well they are together

 

[Magnus]

Take a look at Fleece's "compact compounds" setup if you don't have any plumbing made yet... It's by far the smartest packaging arrangement yet (think stock 6.4 Ford), and I believe they run a cummins 90* discharge S366 over an S475 and the spool and torque development are amazingly linear.

 

[Magnus]

Also you'd have to be sure the turbine sides match, and the S475 is doing more of the "work" if you calculate both as isentropic compressors... But she'll go just fine.

 

[ThebigGids]

Could consider a 364 also

 

[cafryer]

I have ran that setup before and they are just fine spools fast and makes good power

 

[dirtylb7]

I have ran that setup before and they are just fine spools fast and makes good power

How much power we talking? Lol

 

[cafryer]

I made almost 800 with 60% injectors and a single pump