Hey guys, going to be installing my new PPE up-pipes and manifolds this coming week. First off, my direct question is what process is everyone using to make sure you don't snap bolts off when removing the manifolds and up pipes? I'm sure penetrating oil but do you let it soak for a few days before? will I have to heat them (My truck has 40k original miles and all the bolt heads look brand new. However, I know this probably doesn't matter.) My second question is I will be installing these at the same time I install a 63mm turbo, Wherli EGR delete tube with Y-bridge, and Mishimoto intercooler with piping. Should I take everything off from the front of the motor back to make it easier to get to bolts? First time tearing it apart and wanted to have a game plan! TIA :thumb: