LB7: ppe lift pump install
- Thread starter diesel53
- Start date
my pump job looks like its straight out of Compton but hell it works, cut the hard feed line and spliced in the ppe with rubber fuel lines
Dont cut any lines!!!!!! Get a quick disconnect tool from an auto parts store. Disconnect the feed line at the sender and the line above the fuel cooler. Run a new line from the sender to the pump, then from the pump to the cooler.
Just get under your truck and look where the lines run. I've done probably 5 or 6 PPE pumps like this. Sender, pickup, whatever you wanna call it. It doesnt run through the cooler, the line you want is above it. Like I said, just get under there and look.
I think I have a pic somewhere on my PC......The second pic is the line above the cooler. If you lay on the drivers side under the tank, you can reach up above the cooler and disconnect the stock line.
Attachments
Last edited:
I still cut my lines but I used those compression fittings. Then after everything was done installed a temporary clear fuel line at the fuel filter housing to verify the suction side was pulling air. Hope your pump last longer than mine did.
