Powder/Ceramic Coating motor parts
- Thread starter DetailsUnlimited
- Start date
that 2 piece y bridge likes to come loose when its under high boost. i assume you will be running mo powa after the build.
looks nice
looks nice
Just waiting on pistons to get here then the motor will go back together.
Carrillo's
Mahle performance cast 16:8.1
MA push rods
S366 billet batmo
Profab T-4
Profab ups and manifolds
HX 4in down pipe
Clevite HX bearings
Keyed cam and crank
ARP head and main studs
Danville performance modded CP3
I might of missed some things but for the most part thats it.
Carrillo's
Mahle performance cast 16:8.1
MA push rods
S366 billet batmo
Profab T-4
Profab ups and manifolds
HX 4in down pipe
Clevite HX bearings
Keyed cam and crank
ARP head and main studs
Danville performance modded CP3
I might of missed some things but for the most part thats it.
Thx guys! I took them to my buddy at the dealership and he used his hot wash/solvent to clean things up. The powder coater also sand blast and preped/ taped off all gasket areas to.
Looks great please update when all installed
On a side note did they ever catch the guys that took your trailer?
On a side note did they ever catch the guys that took your trailer?
Looks good, too bad you'll only be able to see just a little bit of it. Wish I had thought to do my oil fill tube when I did my other.
X2 . Surprised your reusing that piece. Mine came out with my stock turbo.
X2 . Surprised your reusing that piece. Mine came out with my stock turbo.
Y bridge will be braced properly! I thought of doing something else but money had a big factor with it. And as much stuff as I'm removing you should see all of it.
