p1093

oldwrench

New member
Mar 9, 2017
7
0
1
05 2500HD LLY 170,000 miles

keeps setting P1093 and going into limp in mode. it has no trouble starting, no excessive smoke , and until the code sets runs great.
my understanding is that P1093 is low rail fuel pressure under enrichment, but it seems to set when i lift throttle ,and at low fuel demand. i have replace FPRV (with race plug), fuel rail pressure sensor . and installed lift pump (10psi) does anyone have any ideas witch way i should go with this ?
 

2004LB7

Well-known member
Dec 15, 2010
6,984
2,145
113
Norcal
test the return fuel on the CP3 and injectors. and don't forget the easy stuff like air in the lines and clogged fuel filters. but with a properly installed lift pump that should be less of an issue
 

oldwrench

New member
Mar 9, 2017
7
0
1
i have changed the fuel filter even though it was fairly new just to eliminate it as a possibility. CP3 and Injectors are original i did look at freeze frame data a while ago (this has been going on for awhile) the only thing i remember that didn't make sense to me was a desired rail fuel pressure of 140psi and a currant of 120psi
 

dndj

Boost!
Apr 13, 2019
302
34
28
Oregon
i have changed the fuel filter even though it was fairly new just to eliminate it as a possibility. CP3 and Injectors are original i did look at freeze frame data a while ago (this has been going on for awhile) the only thing i remember that didn't make sense to me was a desired rail fuel pressure of 140psi and a currant of 120psi

I believe those numbers would be in MPa, not PSI. 140Mpa = 20,305 PSI.
 

oldwrench

New member
Mar 9, 2017
7
0
1
ya sorry Mpa. last set of freeze frame data was desired of 120Mpa, actual 103Mpa, @ 2200 rpm. I ran a balance test 675 to 681 accross all 8 cyl. With the scanner on it no matter what i do they are about the same. But when i drive it, it could be half an hour or 5 min but it does it again. i am staring to think it could be an erratic FPR . any thoughts ?