Oil Cooler Delete plate?

[Yellow Jacket]

Does anyone know the best place to order an oil cooler delete plate from? I'm going to a filled block and it will have a dry sump oil system on it...

Possibly looking to purchase flanges/fittings for front and rear of cylinder heads to run coolant just through cylinder heads...

Thanks!

 

[malibu795]

PPE is the only people I know off that carry one

 

[x MadMAX DIESEL]

I was gonna do that but I heard electric pumps don't flow enough water and ppl were hurting heads still.


Sent from my iPhone using Tapatalk

 

[S Phinney]

Speak to Jeremy Wagler and he can lead you in the right direction on that setup. I know most don't want to hear it but Wade Moody could give some good info as well.

 

[Yellow Jacket]

I was gonna do that but I heard electric pumps don't flow enough water and ppl were hurting heads still.


Sent from my iPhone using Tapatalk

I have ran 2 water pumps for 3 years, and have had zero head issues like I experienced the couple seasons before that...

 

[juddski88]

Powermax Performance used to make them too...not sure if he still is?

 

[duramaxzak]

Maybe check with HSP, looks like they have some billet AN adapters for the heads.

View attachment 38378

 

[RickDLance]

I can burn you one. PM me if you want one.

 

[RickDLance]

This one?

 

[Yellow Jacket]

Yes, that one.

 

[malibu795]

What do you got for that rick? I'm stilling chewing on the idea of deleting the cooler on my hotshot

 

[duramaxzak]

Look at post #13, you can mill the stock oil cooler housing and thread the 2 ports.

http://www.duramaxdiesels.com/forum/showthread.php?t=44961

 

[malibu795]

Look at post #13, you can mill the stock oil cooler housing and thread the 2 ports.

http://www.duramaxdiesels.com/forum/showthread.php?t=44961

Outstanding!!! And I got a bad cooler I can chop up

 

[RickDLance]

Yes, that one.

How are you going to seal it up?

 

[Yellow Jacket]

How are you going to seal it up?

I actually have a damaged cooler too, I'm just going to mill it down and tap the 2 ports! I can use factory o-rings then! :thumb:

 

[RickDLance]

Probably the best idea.

 

[Yellow Jacket]

Thanks again Rick!

 

[WI Huck]

With the dry sump oil is fed into both ports then, correct?

 

[Yellow Jacket]

With the dry sump oil is fed into both ports then, correct?

No, just the inlet fitting, the out one from the factory pump out to filter would just get capped...

 

[duramaxzak]

Probably the best idea.

Although there might be a opportunity for someone to cut out some of these covers?! Not sure how much of a demand there would be for them.

View attachment 38415