Not sure. Compressor wheel looks good. Couple small Knicks in the cover but nothing that can't be smoothed out.
Even so came out fairly good
Not sure. Compressor wheel looks good. Couple small Knicks in the cover but nothing that can't be smoothed out.
You're a UGA and FSU fan? Two of the worst choices hahaChanged my oil, fuel filters and installed one of Mike L.'s trans coolers on my LBZ. Would have been easier without a ranch hand brush guard right in the way! Still need to replace Hydroboost but can't stand contorting under the dash to unbolt it! Any helpful tips before I take a sawzall to the dash?
You're a UGA and FSU fan? Two of the worst choices haha
Sent from my SM-N910P using Tapatalk
I can understand your hatred...I'd hate us too if I were a bulldike fan! What part of Florida, I grew up an hour north of Tampa.I'm a UGA fan. Wife is FSU. She can't help it. I'm a FL native and don't like any school in the state....especially the Gayturds
Changed my oil, fuel filters and installed one of Mike L.'s trans coolers on my LBZ. Would have been easier without a ranch hand brush guard right in the way! Still need to replace Hydroboost but can't stand contorting under the dash to unbolt it! Any helpful tips before I take a sawzall to the dash?
Left camper for good in St. George, Utah. Then visited Zion NP. I really like the Bus Shuttle service they provide, banning outside vehicle travel to a good stretch of the park.
Later made it to Bryce Canyon NP and WOW.
Take the drives seat out. 2 bolts, 2 nuts and a wiring loom.Changed my oil, fuel filters and installed one of Mike L.'s trans coolers on my LBZ. Would have been easier without a ranch hand brush guard right in the way! Still need to replace Hydroboost but can't stand contorting under the dash to unbolt it! Any helpful tips before I take a sawzall to the dash?
X2I like the truck
Sent from my SM-G900V using Tapatalk
Josh154, where did buy the clamps at...?[/QUOTE]
You can buy those U-bolts at any TSC store. Look in the trailer section. I personally think he's using too thin of metal for the "bar" under the spring, though. I used 1/4". I hope he doesnt have any problems with them.