I've just rebuilt my motor, after dropping a valve and taking out a piston. Put in lbz rods, arp studs, all new bearings and rings. 2000 miles on rebuild, with 475 over stock twins.
Last night, i finally found some pavement and wanted to get some good pulls in. Got one hard run in, from 55 to 100, pulled over at the local gas station. When i pulled over, the truck had more of a shake to it the usual. I slowly revved it up, and the shake got worse till 1400 rpms, then cleared up, sounds and felt fine.
I figured i better get it back to my shop, So gently drive it home. Sounded like absolute shit. Had a really loud "diesel" sound, like the old ford diesels. It honestly sounded like an up pipe had fell off. I got it to the shop, and went to bed sick and fed up with things going wrong.
This morning, went to go log it, and will not start at all. Doesnt even try to fire. Whit smoke comes out the tail pipe, and fills my shop with raw fuel.
Any ideas guys? Getting a tech two today some time to see if i can find anything out.
Last night, i finally found some pavement and wanted to get some good pulls in. Got one hard run in, from 55 to 100, pulled over at the local gas station. When i pulled over, the truck had more of a shake to it the usual. I slowly revved it up, and the shake got worse till 1400 rpms, then cleared up, sounds and felt fine.
I figured i better get it back to my shop, So gently drive it home. Sounded like absolute shit. Had a really loud "diesel" sound, like the old ford diesels. It honestly sounded like an up pipe had fell off. I got it to the shop, and went to bed sick and fed up with things going wrong.
This morning, went to go log it, and will not start at all. Doesnt even try to fire. Whit smoke comes out the tail pipe, and fills my shop with raw fuel.
Any ideas guys? Getting a tech two today some time to see if i can find anything out.
