New Product!!!! Duramax Silicone coolant hoses

[Dan@PPE]

check em out! available in 6 different colors, 4 ply high quality silicone!
http://www.pacificp.com/store/index...facturers_id=&pfrom=&pto=&dfrom=&dto=&x=0&y=0

 

[N2BRK]

Damn. Now I need to decide what color to buy! LOL

 

[duramaxnate]

I would so put the green hose kit on my 98 Dirty pickle if I was keeping it. :rofl::rofl::rofl:

 

[N2BRK]

I'm boring. I went black. Lol. Thanks Dan!!

 

[MAXX IT OUT]

Any thoughts on doing the hose for the van thermostat housing?

 

[LBZ]

Any thoughts on doing the hose for the van thermostat housing?

This and why not incorporate a drain in the lower hose?

 

[Harbin_22]

This and why not incorporate a drain in the lower hose?

That would make too much sense! I absolutely hate that they don't have a drain. Makes a damn mess

 

[NC-smokinlmm]

This and why not incorporate a drain in the lower hose?

This^^^^

 

[Dan@PPE]

Already working on it...

 

[N2BRK]

that would be awesome! Hopefully retrofittable, since i already ordered

 

[Dozerboy]

I'm boring. I went black. Lol. Thanks Dan!!

Me too. I would have to get the clamps and fittings coated in black to.


Sent from my iPhone using Tapatalk

 

[Dallas S]

Any chance I can get a orange LML upper hose?

 

[Dan@PPE]

that would be awesome! Hopefully retrofittable, since i already ordered

Yes the drain option will be reto-fittable.

 

[Dan@PPE]

Any chance I can get a orange LML upper hose?

LML's are "in stock" in black, color options about about 1-2 months out! They will only be sold in sets (upper and lower hoses).

 

[N2BRK]

:hug::hug::beer

Yes the drain option will be reto-fittable.

 

[N2BRK]

Working on it now. Very nice setup!!

 

[N2BRK]

Overall not bad. The only true bitch was getting the hardpipe attached to the radiator. Lube, heat, and channel locks!

I had two leaks; tightened the clamps some more and they stopped.

 

[x MadMAX DIESEL]

Won't silicone rub through faster than the rubber? There's 2 bad rub points on these trucks


Sent from my iPhone using Tapatalk

 

[Dan@PPE]

Overall not bad. The only true bitch was getting the hardpipe attached to the radiator. Lube, heat, and channel locks!

I had two leaks; tightened the clamps some more and they stopped.

Make sure you thoroughly tighten all the clamps, Would be best to heat cycle it once and re-tighten. Should be good to go after that!

 

[N2BRK]

4mos later and never needed to attend to them again. I'm very pleased.

Did you ever release a drain cock for your kit? I know you were working on something, including a retro-fit option.

Thanks,
Wally