(Truck : 2012 gmc 3500hd slt 6.6 duramax )
Hey guys,
*** How we doing i need your help . So i was driving home i had stopped at a truck stop. And once i pulled out i accelerated a bit to pick up speed since i was towing a car on a trailer. Once i reached 60 i placed it on cruise control when all of a sudden i felt a small fuel cut and then the dash said fuel filter life dropped to 0% and then said change fuel filter then check engine light came on and went limp mode say engine power reduced and then just cut off. I had a couple of people try to help me out some say my cp4 went out some say its electrical. I replaced fuel filter with another ac delco one semi rebuild the primer housing. I just wanna make sure it isnt the cp4 because i know thats expensive and if it is , is it covered by warrenty. We did spray a little bit of starter fluid and it started up. I heard also that the fuel pressure regulator get dirty on the mesh can that be? How can i test the cp4 ?* These were the code i got* P2610, P2493, P128E, P2510, P0087,P154B,P150C. One so call mechanic thought by deleting the codes it would work but the P128E stays. HOW EVER GETS ME TO START THIS TRUCK AND BACK ON THE ROAD I WELL SEND THEM 100 BUCK... JUST HAS TO TELL ME WHAT I COULD BE IF IT WORKS ILL SEND THE MONEY PLEAAASSSEEEEE HELP THANKS
Hey guys,
*** How we doing i need your help . So i was driving home i had stopped at a truck stop. And once i pulled out i accelerated a bit to pick up speed since i was towing a car on a trailer. Once i reached 60 i placed it on cruise control when all of a sudden i felt a small fuel cut and then the dash said fuel filter life dropped to 0% and then said change fuel filter then check engine light came on and went limp mode say engine power reduced and then just cut off. I had a couple of people try to help me out some say my cp4 went out some say its electrical. I replaced fuel filter with another ac delco one semi rebuild the primer housing. I just wanna make sure it isnt the cp4 because i know thats expensive and if it is , is it covered by warrenty. We did spray a little bit of starter fluid and it started up. I heard also that the fuel pressure regulator get dirty on the mesh can that be? How can i test the cp4 ?* These were the code i got* P2610, P2493, P128E, P2510, P0087,P154B,P150C. One so call mechanic thought by deleting the codes it would work but the P128E stays. HOW EVER GETS ME TO START THIS TRUCK AND BACK ON THE ROAD I WELL SEND THEM 100 BUCK... JUST HAS TO TELL ME WHAT I COULD BE IF IT WORKS ILL SEND THE MONEY PLEAAASSSEEEEE HELP THANKS
