Mass dyno day
- Thread starter xcablb7
- Start date
i think the torque readings were off they couldn't even get one for mine the clamp wouldn't hold tight! i saw 1,550ft lb about crapped myself then realized it was an error haha
hahaha ok rich lmm first cheetah to make 1500 + lol
i figured out the math for mine = 1250-1300 depending on the rpm it would fall at, what did yours make in hadley ? can give you a ballpark
i figured out the math for mine = 1250-1300 depending on the rpm it would fall at, what did yours make in hadley ? can give you a ballpark
After watching the tach bounce all over the place & hitting zero during the runs, the math will give you a better answer.
They ran a few more trucks after you guys left & got the mess from that dodge cleaned up.
Pondsy did 372hp on his tow tune & 42Xhp on the big tune. Not bad for a stock tranny & no lift pump:thumb:
They ran a few more trucks after you guys left & got the mess from that dodge cleaned up.
Pondsy did 372hp on his tow tune & 42Xhp on the big tune. Not bad for a stock tranny & no lift pump:thumb:
First time I've ever put one of my rigs on a dyno or attended one for that matter. I was pretty happy with 427/764....for now...lol. Good to meet more of the folks from our area.
dont remind me i started off making 440 wanted 500...got that now i want 650 hahaha
thx josh i'll have to check the sheet only shows mph, think it was right around 100 ? 30.5" tires 3.73 gears
Good power!!!...looks like it pulls up pretty high!
out of curiosity, what kind of boost were you making on that tune?
out of curiosity, what kind of boost were you making on that tune?