MAP sensor

Redbowties88

Redbowties88

Sideways > Straight ;)
Aug 24, 2009
1,943
1
0
609 New Jersey
anyone have the part number? im tired of mine only reading to 28psi and its giving me some hell tuning in dsp format.


i dont think theyre too expensive and not too bad to change IIRC


thanks,
Beech
 
TheBac

TheBac

Why do I keep doing this?
Staff member
Apr 19, 2008
15,615
1,874
113
Mid Michigan
They are not cheap, either. Between $80-100+ depending on make.

OEM part # -- 9373269
Delphi part # -- 12623671
ACDelco part # -- 213-4658

images




Looks like that same sensor fits all Dmax, too.
 
Last edited:
x MadMAX DIESEL

x MadMAX DIESEL

<<<< No Horsepower
Dec 30, 2008
7,535
1
38
34
Lexington, Ky
How did you hook it up? the oil pressure sensor screws in and the map is just oring sealed? Did you have to splice wires too or did the plug work fine?
 
Last edited:
sweetdiesel

sweetdiesel

That's better
Aug 6, 2006
10,390
0
0
52
Thailand
x MadMAX DIESEL said:
How did you hook it up? the oil pressure sensor screws in and the map is just oring sealed? Did you have to splice wires too or did the plug work fine?
Click to expand...

Used a volt meter to figure out the wires
used a old harness with the weatherpack for the oil sensor and then cut the wires off the boost sensor and solder the to the oil sensor

I actually left the stock sensor in place because it was a oring seal and just stuck the oil sensor into the y brige

You can put it anywhere you like or even use it for drive press, lift pump whatever you want to log really?

I used a hand a air compressor and manual gauge and efi to rescale

you could most likely get a sensor and harness from autometer for around 80 bucks
 
You must log in or register to reply here.
Top Bottom