Dropped my heads off at the local machine shop to get resurfaced. They said they could clean up the surface on a large belt sander but to mill the heads they would have to disassemble all the valves. Does this sound right?
Dropped my heads off at the local machine shop to get resurfaced. They said they could clean up the surface on a large belt sander but to mill the heads they would have to disassemble all the valves. Does this sound right?
I think there was just a little misunderstanding. After talking to them further they are going to check all the valves and mill up to .005 off the deck.
Sent from my Nexus 6 using Tapatalk
Huge difference in price depending on your location and the quality of the shop. Give one a call.Whats the average cost to deck heads on a duramax im coming close to that point ?
Sent from my iPhone using Tapatalk
Huge difference in price depending on your location and the quality of the shop. Give one a call.
Sent from my SM-N910V using Tapatalk