Low coolant level warning

[Kappa9012]

after installing twins I disabled most of the codes that I thought were tripping codes and i'm still getting a DIC message about low coolant level that I can't get rid of. Any ideas on how to stop this from popping up.

 

[Mpsoldier]

ADD COOLANT my lmm is touchy on that alsoand idk why.

 

[xtremebikr04]

after installing twins I disabled most of the codes that I thought were tripping codes and i'm still getting a DIC message about low coolant level that I can't get rid of. Any ideas on how to stop this from popping up.

Do you have the coolant level sensor hooked up still?

 

[BlkMax]

Do you have the coolant level sensor hooked up still?

X2^^^^

I replaced the coolant tank with another one from the kit, and then jumped the sensor plug when I added my trips. This was on an LB7, I do not know about any of the other engine models.

 

[Kappa9012]

no the sensor is not hooked up. The expansion tank does not have a provision for that.

 

[JRODS*LB7]

no the sensor is not hooked up. The expansion tank does not have a provision for that.

I think thats y man.:thumb:

 

[Kappa9012]

i know why it's tripping, but is there something i can do with EFI to kill the DIC message.

 

[JRODS*LB7]

i know why it's tripping, but is there something i can do with EFI to kill the DIC message.

I dont think u can because i just checked my DTC MIL enablers and its not on the list

 

[JoshH]

I would try putting a jumper wire across the contacts in the plug.

 

[JRODS*LB7]

X2 on jumper i did it with my lb7 and it worked

 

[Kappa9012]

yeah i just saw the post a bout trents coolant tank and using the 330ohm resistor across the leads.