looking for stock vvt outlet flange

[DuramaxPowered]

I am looking for a place to get an exhaust outlet flange (a flange for building a new down-pipe) for the stock vvt on my LMM. I'm looking at getting the parts rounded up to do a twin build-up, but I'm not sure the size or where to get these flanges. Any help? I don't want to pull the stock down-pipe out to measure and have the truck down for longer than needed.

 

[McRat]

You could start with a Diamond Eye downpipe and cut and bend it.

 

[the4wheeler]

i just might have you coverd on that
i have a ss flange i made for my down pipe but ended up cutting the factory one ( it had a better lip on it for welding) ill throw it your way if you think it might work for you
theirs photos and article over on DP "DIY Redneck Downpipe" or i can git a photo of it in the next day or too
im prity sure your not gona find any one that sells just the flange
i also have a LLY VVT sitting in my shop i can take mesherments of it and my flange but giting the "V" band mesherment might be tricky.

 

[the4wheeler]

the flange it was in my DP garage photos
PM me if you think you can make it work and its yours

and it will have to be TIG welded to your pipe if i rember right the little nub i left was real close to the "V" band surface aria

 

[DuramaxPowered]

measurements would work, I have quite a few buddies that are excellent machinists..... I may try and pickup a core turbo for mock-up purposes... I have an engine here I'm going to try and get the large turbo mounted and hot-pipe/wastegate mount and built out of the truck then put it all in...:rofl:

 

[Fingers]

Where is "here"? I have a shelf full of VVT cores. LLY, LBZ and LMM

 

[McRat]

Here's the dim's for it:

 

[DuramaxPowered]

Fingers, i'm in Monroe, Mi........... Pat, thanks for the dimensions

 

[the4wheeler]

nicely done on the diminutions Pat!!!