LML Marine swap

[Hawk 40]

I've been in Idaho most of the last month so I haven't finished off a couple loose ends. When I extended the compressor snouts I accidentally located the flanges right over an injector line, the bend is so close I don't think I can get the clamp on the flange. Haven't had time to mock up for a new line yet.
If it's not too much trouble, bring your stuff. I can pull one engine out tue. ( they have to come out so I can paint the bilge and fit the heat exchangers).
We built a new test stand that will accommodate the intercooler etc.
Probably be good if you could come by and help with the harness stuff so if I'm missing something I can work on that.

 

[Hawk 40]

Hey my tiggin' is getting better. The round expansion tanks looked goofy where I wanted to mount them so I made up two small saddle tanks that can mount to the upper side of the engine hatch gutters.

 

[kidturbo]

You've really been practicing

I'll text ya when I'm rolling that way. Just waiting on mounting plates from my laser guy. I'm on hold till I know where I'm gonna mount the main heat exchangers. May have to go where you put your charge cooler..

 

[bludelux]

So did this get finished and you're too busy off shore to share or...?

 

[Hawk 40]

I wish.
Momentarily hung up on tuning issues.
Engines will fire then instantly die. Initially was getting a “key immobilizer “ code.
Reloaded different tune and had the same fire and die scenario but forgot to recheck for codes before I left. Stuck at home today with a sick kid, so back on it tonight or tomorrow.
We’ll get it soon, I have really good help. This thread started a hundred years ago because I suck at the electrical stuff and that has not changed much.

 

[trashygasman]

Some updated pics would be nice!

 

[Hawk 40]

Can’t get pics to upload right now but cranked up and ran good on a tune kid turbo sent me.

 

[THEFERMANATOR]

If I had known tune issues were holding you up, I could have helped you out. I'm not that far away and have a little tuning experience. Glad you got it running at least, I know how much that 1st fire up can remotivate you to finish a project.

 

[kidturbo]

I still haven't figured out why it wouldn't fire on the original DSP5 tune.. Found a couple more wires in the lbz chassis harness side that are different from an lmm, but nothing critical. We ran a lmm ecm on Marks dyno with lbz harness and only MAF was missing. I swapped those on this harness.

At first I thought it was because I forgot to set relearn timers to 0 under VATS. But fixed that, still no love. Sent him a non-DSP tune with same VATS parameters and it fires right up..

Only thing I can think is that CAX file mod we did for map scaling doesn't like being upgrade to a DSP os. I'm gotta run it on my bench setup next week and figure this one out.

Sent from my SAMSUNG-SM-G870A using Tapatalk