Lift install complications

[Sirrobbythe5th]

Im putting my 6" zone lift on my truck and everything has gone pretty smooth....that is until now.
I have the front and rear NEW differential drop down brackets installed..and it was kinda a bitch to get the front diff in. I had to jack on the diff quite a bit to get the back holes to line up. But thats in now, However when i went to put my LCA on (they have new bushings)...The LCAs where 1/2" TOO WIDE wtf. So i had to put a bottle jack between the two diff brackets to separate them enough, has anyone else encountered problems like this? I don't like that i had to jack on the diff to get it bolted in...nor do i like that I had to jack the brackets apart. Remind you all the bolts are loose.....so nothing should be this tight!!
Suggestions?? Im about to go back through everything today and see if I did something wrong even though everything is straight forward

 

[Sirrobbythe5th]

Now i just saw another forum that said with the energy bushings I went with that I might need to install the bushings from the inside out. Instead of the factory way- outside in?

 

[Chad006]

Energy bushings went from outside in on mine when I took the lift out of mine, they were quite snug but little persuasion they slid right in. If you could post up some pictures that'd help.

 

[Sirrobbythe5th]

Just switched the bushings around (plenty of grease so I was almost able to do it by hand)
Anywho, the fit perfectly! Thanks
I just wasn't sure if it was "appropriate" for the hats to be on the inside
I will post pictures and do a full write up for installing the lift when I'm done !