lb7 injectors loud under load and completely quiet once I hit 2900rpm ...???

rcfreak24

New member
Oct 1, 2013
23
0
1
I have a 03 lb7. Starts awesome hot or cold no missing no smoke idles great runs good. Under load the injectors are loud but once I hit 2900 rpm the sound is gone completely out doesn't fade out it just stops like you flipped a switch
..

Does anyone have any idea's? It is annoying even with 5" exhaust and radio on you can still hear them ticking on the interstate.

No fuel in the oil either. ..


The truck has no tuning.
 

Hot COCOAL

May the farce be with you
Jun 9, 2012
4,433
0
0
Almost sounds like pilot timing....not sure what the LB7's did, when it came on and shut off

That's normal for the most part, maybe it's an indication of dirty injectors, or possibly a dirty fuel filter?

When's the last time you changed the fuel filter, or ran a good fuel system/injector cleaner like standyne or power labs clean diesel?

Where are the lb7 guys???

Allot of these nuts run 2-stroke or trans fluid or motor oil and all sorts of crud in their tanks with fine results, personally I run standyne, power labs and schaffers, separately of course.
 

rcfreak24

New member
Oct 1, 2013
23
0
1
I'm not sure the history on the injectors but the truck was owned by the government since new. It has 190k on it now. I have put about 4k miles on it.

I put fuel additive in every time I get diesel. Which has made them a tad quieter. I also added a fass 150 titanium and put a new filter on the engine.

The truck runs great starts perfect even when 10 degrees out neve misses or smokes and all balance rates are in spec.

They are noisy and right at 2900 rpm they get completely quiet but the truck still runs and pulls just as good. ..

By the way I use Schaffer oil and additive for the fuel.
 

DIESELMAFIAPER.LB7

<----new hotness
Jan 17, 2010
5,163
12
38
idaho
shop.dieselmafiaperformance.com
Guess I'm a nut for using 2 stroke :rolleyes: sound normal to me I believe the amount of pilot decrease before that rpm but I don't have my laptop in front of me. get you a nice CTS monitor and start watching things like rail maybe it's holding more then desired rail pressure till it gets up to that rpm....
 

Hot COCOAL

May the farce be with you
Jun 9, 2012
4,433
0
0
Guess I'm a nut for using 2 stroke :rolleyes: sound normal to me I believe the amount of pilot decrease before that rpm but I don't have my laptop in front of me. get you a nice CTS monitor and start watching things like rail maybe it's holding more then desired rail pressure till it gets up to that rpm....

Lol, I meant that in the best of taste :angel:

That's the dark side of diesels to me, I'm afraid of the dark....:roflmao:

Lol, So yeah, you're a nut...cuz I'm afraid to do it :hug:
 

03spoolindmax

New member
Nov 9, 2011
674
0
0
36
Mi
I run the walmart 2 stroke oil mixed with diesel Kleen. My injectors always seemed noisey even after the dealer replaced them. When I removed the lift pump before I sold the truck. The injectors were way more noticeable. All injectors were within spec too.
 

rcfreak24

New member
Oct 1, 2013
23
0
1
They were loud before the lift pump. So I installed it just in case. They did get quieter a little with fuel treatment. I may try some 2 stroke oil.

It's just annoying. And when I start the lb7 lly lbz lmm at work all of them are quiet. Can not hardly hear the injectors. Mine is obvious.... sounds like a Damn sbc with loose rockers lol
 

rcfreak24

New member
Oct 1, 2013
23
0
1
I'll check with scanner. They are quiet at idle just under load or like above 1300 rpm you can hear them
 

rcfreak24

New member
Oct 1, 2013
23
0
1
Will this be of any use to yall
 

Attachments

  • 20131213_143244.jpg
    20131213_143244.jpg
    102.9 KB · Views: 53
  • 20131213_143214.jpg
    20131213_143214.jpg
    144.7 KB · Views: 35
  • 20131213_143204.jpg
    20131213_143204.jpg
    112.5 KB · Views: 25
  • 20131213_143152.jpg
    20131213_143152.jpg
    107.4 KB · Views: 26

PhilsLB7

Way Better Than Facebook
Jun 29, 2009
810
0
0
Tennessee
Mine does the same thing under load. More noticeable between 1500 and 2000 RPM. Less noticeable as it goes above 2000. I was told this is normal for LB7's but I just don't remember it being this loud, even with 2 stroke or other fuel additive. I'm going to try the GM fuel injector/Upper Cylinder cleaner sometime to see if it helps. For now just turn the radio up louder.
 

rcfreak24

New member
Oct 1, 2013
23
0
1
Definitely not the valves. It stops like you flipped a switch around 2900 rpm.

Truck was government owned till I got it so it was never tuned. 100% stock
 

Bustedknuckles

Honey Badger
Sep 25, 2010
1,308
2
38
33
Hagerstown MD
Mine does the same thing under load. More noticeable between 1500 and 2000 RPM. Less noticeable as it goes above 2000. I was told this is normal for LB7's but I just don't remember it being this loud, even with 2 stroke or other fuel additive. I'm going to try the GM fuel injector/Upper Cylinder cleaner sometime to see if it helps. For now just turn the radio up louder.

I did that. Helped for like a day. I'm pretty sure its injectors but everything is good other than the noise. Which even though its not that loud drives me NUTS.

Sent from my SPH-L720 using Tapatalk