Is this the same guy that was runnin 10.5 sec drag times with an lmm and a 9 inch lift and 37s with stock tie rod ends. Just wonderin they sound a little alike.
Just saying hello again
- Thread starter sillyboyrs4
- Start date
I beleive so, he is sayin that is his nephew I have been checkin in just to see if he comes back.
yea, but how long can you maintain that rpm, my ecm's been programmed to sustain 5400 rpms for an entire 1/4 run, and at that the egts peak at 1325*
I found his dyno sheet.......
that would make a heck of a badge for the rear of your ferd :joker:
yea, but how long can you maintain that rpm, my ecm's been programmed to sustain 5400 rpms for an entire 1/4 run, and at that the egts peak at 1325*
5400 for a 1/4 of your run your ecm is the least of yuor problems if you are making the claimed hp.
Lets see some pics of the truck, it's ben awhile now with you walkin around this, lets at least see the truck.
, lets at least see the truck.
He's photoshopping them right now....give him a minute.....
It's been a few hours now and still no pics hmm... probably tryin to photoshop someones truck from here could take a while.:baby:
Last edited:
yea, but how long can you maintain that rpm, my ecm's been programmed to sustain 5400 rpms for an entire 1/4 run, and at that the egts peak at 1325*
Careful junior...Make sure your keyboard doesn't write a check that your ass can't cash...
:rofl::rofl::rofl:
Good one!
Must be a stock Dodge 6.7 dyno, 295rwhp. Quite fitting.
oh man not this again
actually i enjoyed it last time...
Welcome back
was the name jay?
and you had a Mike L tranny right but it wasn't our Mike L it was another Mike L in your area.... right?
actually i enjoyed it last time...
Welcome back
was the name jay?
and you had a Mike L tranny right but it wasn't our Mike L it was another Mike L in your area.... right?
I meant to post some pics of the ride today, but my dog ate my camera, i'll get it done tamorrow, I promise