it was a modded bridge so like a 01 but 3", looks like a profab
another one was a cut piece off of the 3" side from a stock pipe welded to the bridge
LB7: Intercooler piping and Y bridge
- Thread starter MAXX IT OUT
- Start date
another one was a cut piece off of the 3" side from a stock pipe welded to the bridge
Ah okay, I think I'm going to chop the reduction off mine and do an aftermarket hot side pipe.
Thanks, been there done that with my old 12valve in high school haha. Dented my fender it came off so hard.
Here are a few pictures I found, This setup was a LB7 style bridge built for an LBZ. But you can see how the LB7 style bridge will connect to the factory coldside location. The next picture is just showing our Max Flow Bridges next to the factory bridge. They are much less restricting...
Feel free to send me a message, or give us a call at (989) 476-0135 We would love to help you out!
Feel free to send me a message, or give us a call at (989) 476-0135 We would love to help you out!
Here are a few pictures I found, This setup was a LB7 style bridge built for an LBZ. But you can see how the LB7 style bridge will connect to the factory coldside location. The next picture is just showing our Max Flow Bridges next to the factory bridge. They are much less restricting...
Feel free to send me a message, or give us a call at (989) 476-0135 We would love to help you out!
Joe,
You guys do a good job with those bridges in directing the air to both banks. :thumb:
Yellowchevy
Evertyime you post a picture you prove that you guys make the best stuff on the market...I mean the quality and attention to detail is ridiculously top notch. :thumb: