Help: How do I......

[bunkerkid06]

How do I tighten up the pipe that comes off the y bridge that goes into my egr delete pipe? It is blowing soot all over the place..... Any help would be greatly appreciated!!!!

 

[TROJAN366]

What pipe are you talking about? Nothing on the intake side should have soot blowing out of it if you have your egr deleted.

 

[bunkerkid06]

It might just be old soot cause someone didn't clean the pipes out when they did the egr delete.... The pipe is the one that comes off the y bridge that you connect the egr delete pipe to then the pass side ic pipe connects to the egr delete pipe right?

 

[bunkerkid06]

Oh that someone would be me by the way, I am the only one to blame for my truck lol.

 

[TROJAN366]

There is an oring where the egr delete meets the y bridge. Make sure it is seated properly and not torn. If you are seeing soot coming out of the bridge then you have a boost leak.

 

[bunkerkid06]

Is it ok if they bridge pipe wiggles a little bit?

 

[TROJAN366]

What delte are you running? I dont think it should move at all.

 

[paint94979]

Please post a decent picture an "egr delete" can mean a few different things.

 

[bunkerkid06]

I'm not sure who makes it I want to say it was a Ppe but not 100% sure and if I can figure out how to post a picture I will.

 

[bunkerkid06]

It is a full egr delete. As in pulled the cooler and pipe out and replaced it with a new pipe, and a lb7 pass up pipe, it doesn't move too much but it does wiggle maybe a quarter inch from side to side.