X2 with enough fuel he will drive the turbo to 30psiHe can adjust the wastegate all day, with a almost stock tune there is not enough fuel to drive the charger hard enough to make 30 psi
Sent from my SAMSUNG-SM-G900A using Tapatalk
X2 with enough fuel he will drive the turbo to 30psiHe can adjust the wastegate all day, with a almost stock tune there is not enough fuel to drive the charger hard enough to make 30 psi
Well it was worth a try,
For me, when I went from a 31.5" tire to a 34" it went from a good acceleration down to a turd. Well I do believe that I could still have towed a decent load like this, basically just dropping down a gear it was not as "fun" to drive as previously.
Then I re-geared it and man what a difference. Feels like I can pull down a house now. I did the install myself front and rear for about $800 or so. Sure made me a believe in proper gearing
I think its in his tuning, but WTF do I know?
That Banks wastegate is a waste of time.
Your truck at best makes 280hp 500ish torque to the tires. The LMM bone stock is probably doing 320hp and 600 torque. You also have taller tires. If you’re going to compare the two trucks get ready to spend a lot of money. Throw some 4:10 gears in it and drive it. It’s not going to keep up with the LMM unless you get a quality converter and built trans.
I get that but the tires on his LMM are huge. Trans in the works, I'll install it and turn up the tune with Ricks up pipes, talked to him thru a PM. :thumb:
Great advice guys, thanks.
I think its in his tuning, but WTF do I know?
That Banks wastegate is a waste of time.
He can adjust the wastegate all day, with a almost stock tune there is not enough fuel to drive the charger hard enough to make 30 psi
Ordered the rebuild kit and TC today.
You can see my truck in my sig, I can haul my rock crawler/trailer (8k) and 900-1000 lbs of gear in the truck bed over a 7% grade at 80mph. EGTs just under 1200. Wouldn't even think of trying it before doing the trans, killed the original one with a 90-100rwhp tune in a 5-4 downshift under too much throttle.
What "rebuild kit" did you get?
I just went through this with mine. I know the PPE stage 5 is just an upgrade kit. My trans had 280K+ on it so I wanted a full rebuild while I was paying the money. Had to buy an extra seal kit ($250). And you better have some extra steels laying around if you have clearance issues. Make sure you have all the tools to check end play as well. Have to give credit to Naylor Transmission on this!
Don't get me wrong I love my trans now, +230 no limp:woott:. But there is a reason Mike and George have the respect that that do. My guy was not going give it back to me unless it was done right, that is hard to find.
There is an old post on here about the clutch pack clearance I will see if I can find it.
I might have been the few but I got a good bang for the buck on this.
I made 22lbs boost completely stock. I first ran a Hypertech in the 60hp position and it still only did 22lbs till I installed the Bighead. Even in the lowest level it ran over 22lbs. I think there might something else going on, with his mileage, that might be giving him low performance.
If a 6.0 Ford with a small tune is out pulling your truck, it has issues.
I might have missed it , did you do the pump rub kit ? If not , with 400000 on it , do it today !!! All that other stuff wont do any good if the truck wont move ! The kit seems to be the last thing most of us want to do because it dosent make power or more noise or look better , but when you take the t case apart and see how close you were to loosing $1600 then you feel alot better !