Heading to track Friday night.

[WolfLMM]

M&H DRs, remove tail gate, backseat, spare. Lower truck all the way this time. Hope I can find a 7.9x pass....

 

[skintback]

Good luck :thumb:


Mods?

 

[WolfLMM]

Suncoast trans, 1054 converter, lift pump, exhaust, Danville race tune, and tierods.

 

[Burn Down]

Put the hammer down Wolf:thumb: I might get to the track next month... 6 hour drive for me, long way to go and hope you don't break something lol.

 

[Moneywellspent]

Thatd be sick! I'm going to a local 8th Friday too. Hopefully I can figure out how to launch this 475. I'm stuck at 8.1 with crappy launches.

 

[NC-smokinlmm]

Thatd be sick! I'm going to a local 8th Friday too. Hopefully I can figure out how to launch this 475. I'm stuck at 8.1 with crappy launches.

Spray that biach...

 

[WolfLMM]

Well I went8.18 and 1.71 60ft time. Got rained out ugh. Truck launched much better this time. Pulls to the left real bad in 4x4

 

[WolfLMM]

Full weight.... Car seat in the back. Tool box still in bed full of shit.

 

[Burn Down]

Car seat was worth a couple tenths:thumb: Good job. Wonder why it's pulling to the left? My truck launches straight as an arrow...

 

[WolfLMM]

Pulls to the left the whole way down the track.

 

[onebaddmaxxx]

Nice run

But back to the basics.
What kind of support/tie rod setup do you have for the front end? How was the cv angle looking?

 

[WolfLMM]

Tierods. Cvs were still slightly positive. I'm removing lift keys this week. Didn't launch really hard this time on account of that fact. Front end is whining also. Forgot to mention that.

I'll post a video in a minute. You can hear the whine.

 

[WolfLMM]

[YOUTUBE]8MoZzufaE6g[/YOUTUBE]

 

[TheBac]

Dragging caliper?

 

[Moneywellspent]

Spray that biach...

Been thinking about it, I feel as if I could use more fuel too. At this point idk if I need more fuel or if 7k pounds is where I should be at. My rear tires do spin for like 15-20ft though. I guess I can try cutting some more weight and getting some qa1s

 

[zf>allison]

If it only whines in 4x4 maybe a bad bearing in the diff?

 

[mudygmc]

Does it only whine going down the track in 4wd? Or all the time in 4wd? If track only and pulling left I would investigate the steering components. Tie rods, centerline flex or idler arm flex. I had to gusset my idler arm mount as I twisted it up pretty good. My tires would squeal the whole way down the track.

 

[NC-smokinlmm]

Is it coming from the front end or transfer case?

 

[WolfLMM]

I'm gonna check the front end this week. I know something has to be bent.