Does anyone have a front/ rear main install tool they would be willing to take some measurements for me? I'm planning on building the tools, but I dont have anything to measure.
Front and rear main seal tool
- Thread starter danzick
- Start date
I don't, but when I've made seal driving tools in the past (like pinion seals), I buy the new seals and takes measurements from those. Just a thought if you don't get measurements elsewhere.
For the price, the MA tools are worth it. Or you can go the route I did and buy a GM kit off ebay for cheap-ish.
I have my own machining equipment, and lots of solid steel stock, so for the one time use, the MA tools aren't worth it for me.
I bought the Merchant tools, definitely worth the money. I would take measurements off your new seals as well as measure the installed heights to get your offsets if you want to make the tools yourself.
Merchant front one works well. Rear one works but not as good. The alignment dowl screws ya and it allows you to go to far if not careful.
hard to tell the installed heights with nothing to go by other than guessing from pictures. I'm hoping someone will tell me the depth that MA machined the inside to.