Hi,
I have a spare ecm for my lbz that i have a dsp5 program on. It started running bad this morning and I swapped the stock ecm back in and it ran fine. After work i was going to reflash the dsp5 tun file back in and I get the following errors
EFI live detected the ecm may not have valid calibration
flashscan is not able to determine the liscense status of the ecm
then it says the ecm is in an unknown state and disconnects.
Any ideas??
Thanks
I have a spare ecm for my lbz that i have a dsp5 program on. It started running bad this morning and I swapped the stock ecm back in and it ran fine. After work i was going to reflash the dsp5 tun file back in and I get the following errors
EFI live detected the ecm may not have valid calibration
flashscan is not able to determine the liscense status of the ecm
then it says the ecm is in an unknown state and disconnects.
Any ideas??
Thanks