LLY: DSP5 Tune will not work

[Sandracer799]

I am trying to set up a DSP5 tune on a buddies 04.5 LLY truck. I have followed all the instructions to the T.

The pins are seated all the way in the connector for the DSP5 knob. My tune I used the hottest tune as the base tune and copied and pasted all the tables from the other tunes in.

From what I have read I have done all the correct steps (many times) and the tune still does not work. I even put another switch in it in case the one I got was bad.

I don't know what to do. Will someone take a look at my tune and see if they see anything wrong with it? I am willing to pay.

Thanks

 

[bluecollar]

how do you have the voltage set up for the switch.. so does it load the tune at all..

 

[Bonestock]

how do you have the voltage set up for the switch.. so does it load the tune at all..

Also double check your pinout & connections! I have had this with just a pin not seated all the way.

Log dsp5 position & check your voltages when you turn the switch.

 

[Janimal444]

Did you do a "Full Reflash" when you flashed in the tune?

 

[bluecollar]

Did you do a "Full Reflash" when you flashed in the tune?

X2 is a lly like a lb7 where it doesn't save the calibration files with a cal flash? op you could always read the tune again to make sure it converted and saved the dsp5 cal

 

[S Phinney]

I would bet on a pin. They come out very easy on a LLY when trying to put the harness back together.

Sent from my DROID RAZR using Tapatalk 2

 

[Sandracer799]

how do you have the voltage set up for the switch.. so does it load the tune at all..

All the voltages are at 0. That has got to be what it is. Thank you so much!!

 

[bluecollar]

yep and the set time between switch changes to 30.. anytime man. efi live gets me everytime I plug it in