Custom intake

[dracing70]

 

[emiller3]

:coolspot:

 

[dmax711]

looks great man! :thumb:

 

[yellowchevy]

Again good work!!!!
:thumb::thumb:

Yellowchevy

 

[dracing70]

Thanks everyone. Hope it works well if not the next will definitely be steel. Aluminum is too much of a b____!!!!! Lol

 

[dmax711]

Thanks everyone. Hope it works well if not the next will definitely be steel. Aluminum is too much of a b____!!!!! Lol

i wonder if anyone has tried making a steel intake ?

 

[dracing70]

i wonder if anyone has tried making a steel intake ?

I wouldn't c why not u can still maintain the weight savings by utilizing much thinner material. Plus I would have a third of the time in a steel one rather then the aluminum.

 

[CurtisEmery]

I will be building one for the puller in the new year.

 

[dmax711]

I wouldn't c why not u can still maintain the weight savings by utilizing much thinner material. Plus I would have a third of the time in a steel one rather then the aluminum.

I agree, ive always wanted to make one but the one thing that has stopped me is welding the aluminum.

 

[dmax711]

I will be building one for the puller in the new year.

be sure to keep us updated man!:thumb:

 

[CurtisEmery]

Will do. I will probably do mild steel. If 304 isnt too expensive I may do it in stainless.

 

[juddski88]

what if you extended the front legs further forward closer to Cyl 1 + 2...just move the fuel lines....?

 

[dracing70]

what if you extended the front legs further forward closer to Cyl 1 + 2...just move the fuel lines....?

Yes u can. That was the only issue. Being the fuel line. I did not want to redo fuel lines. But I don't believe that with the amount of air moving in with the one I built I don't think u will notice. Mine is only about 3/4 inch off from a direct route

 

[ChevyDieselLLY]

What size turbo are you going to be using

 

[dracing70]

What size turbo are you going to be using

3.0 charger with a race cover not sure which one have a few possibilities right now

 

[McRat]

Very nice. :thumb: