What did you do with the 9th injector line if you didn't plug it? After more than 2 phone calls and them saying I wasn't doing it right EVEN after I gave them specs of their plug that was wrong they just ignored me and didn't return any more phone calls. Sorry but that's terrible customer service.
After arguing with them on the first phone call they finally agreed to send me another plug.
New plug didn't fit. I called a second time. They said my return line must be jacked up. Or I was doing it wrong. So I ordered a new return line from GM. It didn't fit in it either.
Called them again. They said I was doing something wrong. So I ordered the Fleece plug. It fit perfectly fine. So I measured their plug, measured the Fleece plug, and measured the factory fitting. I documented everything and called again.
When I talked to them his time I started explaining how I purchased a fitting from Fleece and it fit fine. Then I started to explain to him the difference in measurements and why their plug wouldn't fit properly. He wouldn't even let me finish. He cut me off with a laugh! Yes he laughed at me and said he was pretty sure they knew how to measure stuff. By this time I could have reached through the phone and strangled this asshole!
So I said fine. What are you going to do about the fact your fitting won't fit either of my return lines, and the Fleece fitting does. He suggested I run the Fleece fitting. So as far as I'm concerned wherli can pound sand. And I figure with someone from wherli suggesting I run he Fleece fitting because it actually fits and is made correctly then I might as well just buy the Fleece kit in he beginning.
All company's can have bad days, bad answers on occasion etc. But the moron at wherli had multiple chances and he failed miserably. And consequently he ruined wherli fabrication for me forever.
Sent from my iPhone using Tapatalk Pro
