CP Carrillo pistons, anyone running them yet?

[BigDMax05]

Anybody running a set and how are they holding up?

 

[hipp11B]

Cknight199 is I'm pretty sure and from what I've seen on his build thread they have held up fine with the limited miles they have on them. Might try sending him a pm!


Lbz, built trans, efi by Danville, Danville 68, full egr delete, mbrp down pipe, 5" mbrp to 7" stack, ppe guages, custom traction bars, airdog2 165, ppe fuel rail mods, s&b, afe blade runner, Arp head studs..died March 2015

Parts collected for the build. SoCal super damper, SoCal billet flex plate, SDP S400 kit, II 85% CP3, PPE manifolds/up pipes, PCV reroute. Slowly but surely lol

 

[mike diesel]

I don't recommend them at all. Every motor I've seen with them have puked oil. They had determined there was an issue with how the rings were setup is what I have been told. We pulled a set out of a buddies truck that would loose a quart of oil every dyno pull. Swapped in standard mahle forged and zero issues since.

 

[DMAX497]

Mikes buddy would be me...

The cp are out and I have MAHLE forged in now.

 

[BigDMax05]

Wow ok thanks fellas! Where are we at with street driving forged Pistons?

 

[TheBac]

There was a thread about them two years ago.

http://www.duramaxdiesels.com/forum/showthread.php?t=56576

Too bad they promote oil usage. Nobody needs to waste money.

 

[Mikey]

Call Chris LaDuca @ Ross Racing Pistons

 

[x MadMAX DIESEL]

Maybe incorrect ptw or gap


Sent from my iPhone using Tapatalk