Biggest Turbo Setup That Runs Low to Mid 10's

duramaxdiesel

duramaxdiesel

Dmax Nut
Oct 23, 2008
1,378
0
36
47
Montreal, Canada
...and that I can run on the street. I already have two new turbos from Fleece sitting on my shelf in the garage, a S366 and a S480. I believe these will get me to my goal but to be honest, my buddy is having his motor built by Brayden and he and I are in a pissing match:D So now I ask you my friends, what setup should I use to stay ahead? Should I just sell my Fleece turbos and go bigger? Or say f#@k it and go triples? I'm sure that I can recoup some of my money selling what I have now but will wait to sell them until I know where I'm going. Thanks in advance!

Nick
 
JD Dave

JD Dave

In way over my head
May 19, 2008
2,388
0
0
Caledon, Ontario
duramaxdiesel said:
Can I still drive on the street with that combo?

Nick
Click to expand...

I have basically that setup and yes you can drive it on the street but it's dangerous. When the turbo's lite in 2wd at 60 mph the thing is an accident waiting to happen, fun as heck though. Dimitri drove a set like you want around 1000 miles to an event in Canada and ran a 9 sec pass and then drove home this year if I remember right.
 
TeaBagger2006

TeaBagger2006

Im a Garrett Nut Swinger
May 11, 2008
3,123
15
38
Bis ND
dimitris is a gt5544.... makes me drool thinking about a set up like that.....and like JD dave said, that rush when the big one lights.:woott:
 
duramaxdiesel

duramaxdiesel

Dmax Nut
Oct 23, 2008
1,378
0
36
47
Montreal, Canada
JD Dave said:
I have basically that setup and yes you can drive it on the street but it's dangerous. When the turbo's lite in 2wd at 60 mph the thing is an accident waiting to happen, fun as heck though. Dimitri drove a set like you want around 1000 miles to an event in Canada and ran a 9 sec pass and then drove home this year if I remember right.
Click to expand...

Just reading this put a shit eating grin on my face:woott: That's what I'm after. I want to do this on fuel only but will still install a NOS kit just in case I need it;-)

Nick
 
TrentNell

TrentNell

Finally underway !!!!!
Jul 7, 2008
7,543
0
0
44
slc tuah
duramaxdiesel said:
...and that I can run on the street. I already have two new turbos from Fleece sitting on my shelf in the garage, a S366 and a S480. I believe these will get me to my goal but to be honest, my buddy is having his motor built by Brayden and he and I are in a pissing match:D So now I ask you my friends, what setup should I use to stay ahead? Should I just sell my Fleece turbos and go bigger? Or say f#@k it and go triples? I'm sure that I can recoup some of my money selling what I have now but will wait to sell them until I know where I'm going. Thanks in advance!

Nick
Click to expand...

I dont think the S366/S480 will get you there , I dont know of any one that has ran faster with it than i did ( 11.0* @ 124 ) other than when Max'd Out had one on there , triples get my vote due to there cheaper or same cost than any of the other "big" ( 95mm or larger ) twin kits , and spooling between a S475/PBK set and the triple turbo equivalent are not even close to compare , Matts truck could still tow a trailer with a TCM tune and he ran 10.4 @ 132 on 45% sticks , some 100% over s and he would easily run 9's . He still uses the truck to haul hay too :D

[YOUTUBE]Cpige-hV0CY[/YOUTUBE]
 
bigbird

bigbird

Member
Sep 18, 2006
837
0
16
Edmonton, Alberta, Canada
If you want something that runs mid 10's and is decent on the street run triples. If you're okay with High 10's make your 480 a gt 47 or the little 55 and you're there. All depends what your definition of decent on the street is.
 
dordtrecht5

dordtrecht5

Regular Cabs Rock
Jul 21, 2009
900
0
16
Wherever I am working
Don't know much about the triples, but isn't he like 2/3s there? Why not just buy another 366 and use the two on the 480? Or, is that too much?




Sent from my iPhone using Tapatalk
 
duramaxdiesel

duramaxdiesel

Dmax Nut
Oct 23, 2008
1,378
0
36
47
Montreal, Canada
dordtrecht5 said:
Don't know much about the triples, but isn't he like 2/3s there? Why not just buy another 366 and use the two on the 480? Or, is that too much?




Sent from my iPhone using Tapatalk
Click to expand...

Actually I don't think it's enough:roflmao: I don't know enough about the triples either but will be in touch with Trent very soon;) I think the S480 will be too small and maybe the S366's will cause too much restriction???

Nick
 
TrentNell

TrentNell

Finally underway !!!!!
Jul 7, 2008
7,543
0
0
44
slc tuah
duramaxdiesel said:
Really??? If that is the case I'll use what I have :thumb: Trent, check your PM's;)

Nick
Click to expand...

There is no set kit , we custom make every set to what the customer is after, and the HP level desired . And to any one i have talked to about a kit and went over details ( which we rarely do till kit is purchased ) , the info we discuss i expect to stay between us .
 
dmaxvaz

dmaxvaz

wannabe puller
Nov 22, 2006
1,132
0
0
46
METRO DETROIT
What kind of hp potential would 3 billet s366 t4s have with a stroked cp3 (120% over) and 45% over injectors with a built bottom end have?
 
You must log in or register to reply here.
Top Bottom