Alternate HP fuel line routing for dual fueler

[moparkxracer]

Don't suppose you'd remeber what lines they where do you?

I just used some factory lines that I had and bent them to see how it would line up.

 

[Burn Down]

albumid=253&pictureid=5988[/img]
Here is a pic of the lines on a core motor I use to test fit parts.

What lines are those? LB7's?

 

[95 z71]

Don't suppose you'd remeber what lines they where do you?

Ballance line is lly and the others are from an lb7.

 

[moparkxracer]

Sweet, Thank you!

 

[quadracer37]

dracing70 made mention that Columbus Diesel Supply makes a hard line with DMax 14mmx1.5 fittings on it that you can then bend yourself. Guess you could also ask them if they can make a custom bent one.

Likely only rated for P-pump pressure and not common rail high pressure. To thin of wall; I would verify their pressure rating before using them, I have seen people try and use p pump lines and it does not end good!! Just FYI :thumb:
It is optimal to feed one pump to each rail if and whenever possible!