Like title says got.my ABS light and park brake light wont turn off after I replaced a caliper on the brakes do I need to reset the ABS module If so can I do it with efi live?
abs light wont turn off after new caliper?
- Thread starter DIESELMAFIAPER.LB7
- Start date
Check the codes and I bet you come up with a wheel sensor error. Chances are you disconnected or pinched the wires to the sensor.
I had some issues early on with my LB7 and the ABS. It was before I started using EFILive, took it to the dealership and they reflashed the truck, I assume the ABS controller.
Apparently it was something with low voltage during starting.
I had this issue on my 01, and my 03.
BTW, EFILive can only do the ECU and TCU...nothing else...
Apparently it was something with low voltage during starting.
I had this issue on my 01, and my 03.
BTW, EFILive can only do the ECU and TCU...nothing else...
My lights come on if my parking brake moves AT ALL. Last time it was millimeters but the lights were both on
My 01 did the same thing i had to replace the abs module under the truck i cant rem but boy it was high
Well I checked the wire its fine not.even scratched I took care in doing this so I'm stumped I did have my.batteries un done for when I was pulling my Turbo an valve covers could that have messed with it? Could simply taking power from the ABS then putting it back reset it?
I had some issues early on with my LB7 and the ABS. It was before I started using EFILive, took it to the dealership and they reflashed the truck, I assume the ABS controller.
Apparently it was something with low voltage during starting.
I had this issue on my 01, and my 03.
BTW, EFILive can only do the ECU and TCU...nothing else...
I've had the same thing happen to my truck. There's a bulletin out there for the reflash.
And EFI can only program the ECM/TCM. It can read codes from all the modules though