Anyone have any good ideas you've used or pictures of what you've put on your truck for safety loops? About to try to build some or buy some if anybody knows where to get those as well, thanks in advance.
4wd Driveshaft Loops?
- Thread starter brokesmoker
- Start date
There are some posts on here of people fabbing them themselves if you search.
Or Tony at DHD sells them….
Or Tony at DHD sells them….
I need to do both but really want to make sure front can't move since it's under my legs
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
For the front you can fab one that bolts to the LCA bracket, the two bolts. The rear if the front dshaft is harder because the torsion bar cross member is there
This is all I did for mine:
Yeah, that rear shaft would probably have wiped out my DIY-special, but in the end, it worked just fine.
Yeah, that rear shaft would probably have wiped out my DIY-special, but in the end, it worked just fine.
I like those Tom. Simple yet some decent added security. I'll have to copy those here whenever I push the truck back into the shop.
I have a full set of the DHD ones I'd sell. Brand new never mounted, I bought them and had them powder coated. I'm im the DC area.
Did you make those all yourself? Also how are they when it cones time to do an oil change? Pain in the ass?
I had a local fab shop make these. The front ujoint shield (on the forward driveshaft) sits well below the oil filter but some oil still does drain down across the edge of it when you swap the filters. Not a big deal really.
I like that front shield. That is nice! I don't have one on mine cause I don't need it for rules and there is not much room. I'll have to think about getting one but I don't know of anyone breaking that joint ever
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Those are nice. Looks like they wouldn't be too hard to make..I might have to fab some up for my puller this year.