45% overs again or 60% overs hmmm

[DIESELMAFIAPER.LB7]

Hmm well guess i may go 60s

 

[hondarider552]

what you doing with them 45's?

 

[delong_1]

If you are going through ddp for nozzles again I honestly dont see the need to go larger than 45's mine are about 50% over and they did 1016hp with a 2900 pulse.

 

[S Phinney]

I've had both and if you are not going with a lot of air stay were you are. The 60 overs can do much more than DD can require.

 

[Chevy1925]

So i can do that mod right just use a 1/16 drill bit and drill nozzle out right :rofl:

And James i just wanted new nozzles stockers

Ill come up there and take them back!! Lol

 

[Harbin_22]

40's here and pushed her to 7.20's with no smoke after the spool.

 

[whitelmmmax]

I love my 100s. Nothin like running stockish pulse width and roasting 35s:woott:

 

[DIESELMAFIAPER.LB7]

If you are going through ddp for nozzles again I honestly dont see the need to go larger than 45's mine are about 50% over and they did 1016hp with a 2900 pulse.

Exergy tips i have Extrude Hone tips now i love how 45% overs drive spool and no smoke unless i want it to

 

[DIESELMAFIAPER.LB7]

Ill come up there and take them back!! Lol

Well you can come hang out ha ha cause there going to exergy tomorrow think all my underlining issues are from the extrude tips but id have to have them looked at to be 100% positive just my thoughts not a fact

 

[Chevy1925]

Well you can come hang out ha ha cause there going to exergy tomorrow think all my underlining issues are from the extrude tips but id have to have them looked at to be 100% positive just my thoughts not a fact

lol yeah, then if they are good, sell them to lil bri bri. he needs pursuation to buy a set or have his done

 

[DIESELMAFIAPER.LB7]

lol yeah, then if they are good, sell them to lil bri bri. he needs pursuation to buy a set or have his done

Ill get him to guess ill have to send them off and have them checked out