So here’s an update. Since my first post things have been ok till today. Almost home with temps in low 40s and check engine comes on. Power gets reduced however since I was close I limped it home. Get in the drive and I attempt to clear codes however this tine they won’t clear and truck will not start. Codes come up p2627, p228b and p228c. So after a few minutes of frustration and no success I unplug the derringer from under the hood on the two sensors and plug factory harness back in. I get in and then I’m able to clear codes and truck starts. We will see tomorrow how it runs however signs right now point to an issue with the derringer. Thoughts?