just replaced head gaskets im getting fuel to the injectores and i think its firing because theirs smoke
2005 chevy lly truck wont start
- Thread starter kdesrosier
- Start date
Do you have any visible fuel leaks , any fuel leaking under the truck on to the floor ? Also try to get a scanner of some sort that can monitor actual rail pressure and see what that is while cranking
i cracked the injector lines and used the hand primer till fuel came out of eatch one now im going to search for a scaner
Scanner needs to able to monitor actual rail pressure while cranking over , try to get that and post it up .
is their any way the fuel lines could be mixed up should the supply line go directly to the injection modual then the filter
I just did my head gaskets in my truck which is the same year, It took about 5 times pumping the primer hard and about 2 minutes of cranking before it fired. I would post the codes and make sure you have everything plugged in, I had forgotten my MAP sensor and I thought it was a fuel issue too.
If it turns a couple times and stops setting isn't plugged in I bet. It should crank for a good 15 sec or so before it kicks out. Check your big bale connectors and make sure they are seated and also you should look and see if any of their pins slid out.
ok it started but its still in limp mode i can only get about 2000 rpm , and quit after about 1.5 min runing
You will probably have to clear limp mode with a code reader,should be P0700, unhooking the batterys and cycling the ignition over did not help me.
i cleared all 12 codes and cranked it for acouple cycles and got 2 codes back first one c0035 secound b00229 any help appreciated