0-60 time

[TrentNell]

what is a realiable way to test 0-60 time , i can do it in a log but is it a reliable # .

 

[JoshH]

Doing a log is the most reliable way to find your 0-60 time. When you get the log, look at it in dashboard B mode, highlight from 0 right before you take off until you just hit 60. look at the lower right side of the screen, and it will show the elapsed time covered by all the frames you highlighted.

 

[paint94979]

Doing a log is the most reliable way to find your 0-60 time. When you get the log, look at it in dashboard B mode, highlight from 0 right before you take off until you just hit 60. look at the lower right side of the screen, and it will show the elapsed time covered by all the frames you highlighted.

Best way to do it.

 

[TrentNell]

good to know what kind of #'s are you guy's seeing ?

 

[JoshH]

This log shows 3.9 seconds.

 

[TrentNell]

This log shows 3.9 seconds.

:cool2: , i am going to have to check one of my logs . i know its not that fast though ... i would be happy with anything in the 4's

 

[malibu795]

im at a slugish 5.1 0-60mph

0-100mph was 12.9 seconds lol

 

[TrentNell]

from my log 2 days ago its lookin like 1-60 is 4.21 , 0-60 4.35 on a boosted launch .

not to shabby , now that i know i can maybe work on some launching stuff without being at the strip... though i know the traction is way diff .

thanks guys for the info :hug:

 

[malibu795]

im at a slugish 5.1 0-60mph

0-100mph was 12.9 seconds lol

i just reliszed this...

the slip on this was 13.77@99mph
logged data as 0-100 in 12.9


something seams off here

 

[juddski88]

hmm...with my 33" toyo MT's and weighing around 8200lbs everyday, i logged a boosted launch without my e-locker on and it was 4.61, with a ton of wheelspin on the start, i went off the elapsed time of 0-the time it said 60 2nd time (it said 60 at like 4.1 but then it dropped to 58 then back to 60)

 

[TrentNell]

i just reliszed this...

the slip on this was 13.77@99mph
logged data as 0-100 in 12.9


something seams off here

i only had a few logs to look at , but mine seemed to be pretty close if you factor in that you will get a few mph by the time you cross the beams to start your time ... mine were a little slower than the timeslip so this makes sence ... not shure on yours adam .

 

[malibu795]

unless i am spining my tires the whole dam time :baby:

 

[TrentNell]

unless i am spining my tires the whole dam time :baby:

baaaah i garentee you will not spin them past 30 mph in 4wd . i cant :baby:

 

[malibu795]

baaaah i garentee you will not spin them past 30 mph in 4wd . i cant :baby:

sounds like you have a "lack of power" porblem :baby:

 

[MMLMM]

4.39 0-60mph.

thats with a 13.02 1/4 run. 4x4 boosted.

 

[A_T_Ver]

I think this is kind of close. Fun too!
www.bmdmax.com/downloads/draguess.exe

 

[dbtravis]

mines really high, it said 9.9 on my edge to 60 (65) on the speedometer... 2wd, power level 3

 

[12secondhandshaker]

I think this is kind of close. Fun too!
www.bmdmax.com/downloads/draguess.exe

I used this and calculated all 4 methods and averaged the results of my two fastest runs:

12.829 = average 0-60 of 4.205
12.858 = average 0-60 of 4.228

Overall average of 4.217

Not bad for a shifty truck

 

[beach_33]

at what psi are you guys leaving at. i left at 10psi and i got a 4.7 to 60mph with out a hint of wheel spin so i could probably be faster to 60 with a 15psi launch

 

[TrentNell]

at what psi are you guys leaving at. i left at 10psi and i got a 4.7 to 60mph with out a hint of wheel spin so i could probably be faster to 60 with a 15psi launch

the one i logged was @ 2300 rpm ... i didnt log boost . but i am usually 12-14