Search results

Search the forum Search Articles
  1. farris3161

    LLY: P0340 and p0341

    Fixed. Turns out I got two bad sensors from kragen and two bad ones from napa. Went down to rpm motorsports for some help with diagnosis and tried another sensor and the engine light went out. Sent from my ADR6400L using Tapatalk 2
  2. farris3161

    LLY: P0340 and p0341

    I installed a new to me lbz long block in my 05 lly. This is the second lbz in this truck. The first lbz spun the mains. I cut the tooth off the reluctor wheel and installed the lly induction turbo injection and harness from my original lly. It cranks and cranks with no start and throws a p0340...
  3. farris3161

    truck towing pictures...

    The Impala turned elcamino is just someone I was passing on the freeway I thought u guys might get a kick out of Sent from my ADR6400L using Tapatalk 2
  4. farris3161

    truck towing pictures...

    Airing down on the beach Sent from my ADR6400L using Tapatalk 2
  5. farris3161

    all sorts of weird issues lbz

    Witch side of the fuse did u pull from. Supply side or demand side? If it was the supply side (before fuse) its possible it shorted a relay or control module. Check if the fuse still has power when the ignition is on. Sent from my ADR6400L using Tapatalk 2
  6. farris3161

    all sorts of weird issues lbz

    I'm pretty sure tbc is your trailer brake control. I'm not sure if pulling power from it would disrupt it but try to unplug the trailer bake controller to make sure its not shorting out. Just a shot in the dark. Maybe someone else will chime in. Sent from my ADR6400L using Tapatalk 2
  7. farris3161

    all sorts of weird issues lbz

    Were did u pull power for the remote wire on the amp. Or are u using an aftermarket stereo? Sent from my ADR6400L using Tapatalk 2
  8. farris3161

    Low oil pressure??

    If u are in ? About bearing failure cut open your oil filter and look for metal. I drove mine for a day thinking it was a sensor and decided to do an oil change and cut the filter open to be on the safe side and saw metal. I got it tore down this week and mains were shot. The pin on the crank...
  9. farris3161

    Low oil pressure??

    Sensor is driver side between motor mount and oil filter housing. Either put a manual gauge on it to check it or just replace it. Their about 70$. Mine had the low oil pressure message and I tore it down this week and found out it spun the main bearings. Sent from my ADR6400L using Tapatalk 2
Top Bottom