Search results

Search the forum Search Articles
  1. number_one_scott

    P0089 Fuel Pressure Fault after lift pump

    Hello, I have recently installed a FASS 150 lift pump on my LB7 - intermittently when ever I scan for faults I will have a P0089 code registered - Fuel Pressure Regulator 1 Performance. The lift pump is producing 10psi and is turned all the way down. I have heard of people putting in LLY fuel...
  2. number_one_scott

    03 Silverado, tow setup with airbags?

    Hello, Trying to achieve the best ride / tow ability yet not have any problems with axle wrap. From what I've read, firestone air helper bags with the over load springs removed, nice set of shocks and traction bars is kind of the best of all worlds :thumb: Anyone here running a similar setup?
  3. number_one_scott

    Edge EGT Pyro Gone AGAIN ?!

    Edge tells me its because one of my engine grounds is poor but that wouldn't explain why it is damaging the EGT probe and the EGT probe only?! It wouldn't be a bad idea to check all my grounds anyhow but I find this really hard to believe......:confused:
  4. number_one_scott

    PPE Stage 5 LB7 Allison 4-5 Shift delay??????

    ** Update, did a trans service last night, both filters were clean same with trans fluid. Almost nothing on the pan and spin on filter magnet. Replaced fluid with TES 295 BP fluid. No problems. BUT I will have to keep you guys posted I cleaned my MAF sensor as it was filthy wonder if this was...
  5. number_one_scott

    PPE Stage 5 LB7 Allison 4-5 Shift delay??????

    Okay, I will start with a trans service, I only replaced the spin on filter about a month after having the trans built. Will do the inner filter as well.
  6. number_one_scott

    Edge EGT Pyro Gone AGAIN ?!

    Only concern is I would have to get one with same thread pitch as my exhaust manifold hole for the probe. :confused:
  7. number_one_scott

    PPE Stage 5 LB7 Allison 4-5 Shift delay??????

    Would lift pump cause problems? Excessive fuel pressure at light load? Currently running 10PSI This is the most recent part ive installed on the truck within the past couple months.
  8. number_one_scott

    Edge EGT Pyro Gone AGAIN ?!

    Sounds good, Will most likely get a analog gauge. Thank you for the advice!
  9. number_one_scott

    PPE Stage 5 LB7 Allison 4-5 Shift delay??????

    Mike, good point about software. Batteries are 6 months old. Been daily driving truck so no low voltage. Havent contacted builder yet, trying to see if I can self diag the problem first. What do you think about getting a dealer to scan the truck? I have intermittently had a transmission...
  10. number_one_scott

    Edge EGT Pyro Gone AGAIN ?!

    Hello everyone. Edge has been kind enough to warranty the past 3 Pyro probes for my Duramax. I have a Edge Evolution monitor for gauges and a Edge pyro for EGT's. I had the truck for 3 years, first 2 pyro's have been reading stupid high, truck would be at idle reading 2000 degrees. Now the third...
  11. number_one_scott

    PPE Stage 5 LB7 Allison 4-5 Shift delay??????

    Hello, I have a 2003 LB7 with a PPE Stage 5 rebuild with a 1057 converter. Rebuilt trans done way back in August - wasn't having problems until about a month ago. Under light acceleration, I know the trans will shift from 4th into 5th at around 68-70 km/h. NOW , With light throttle pressure the...
  12. number_one_scott

    Project BlackMax

    Thank you! 1.5" spacer. Front wheels stick out a touch but nothing crazy. Rears pushed the wheels out just right.
  13. number_one_scott

    Project BlackMax

    Factory, dealer take off's. Running adapters.
  14. number_one_scott

    Project BlackMax

    What do you think so far?
  15. number_one_scott

    Hello from Oregon

    :welcome9:
  16. number_one_scott

    New member from BC Canada

    Hello everyone! New to the forum!! :Canada_Flag:
Top Bottom