Search results

Search the forum Search Articles
  1. B

    2015 gmc hard start after warmed up Need Help

    Truck starts right up when cold but once it gets to temp and try to shut off/start it turns over 2-4 seconds, Truck had a tune with a 5 position switch before I bought it and exhaust. Egr was already unplugged from the tune so we romoved it along with the def tank. Also added a lift pump and...
  2. B

    Crank shaft roll pins sheared off Reluctor wheel

    Feel free to call me if you have this issue. I can see the tool
  3. B

    Lbz 6 speed transmission getting over 200

    Melbourne Fl
  4. B

    Lbz 6 speed transmission getting over 200

    Ya I figured, not looking to make a bunch of power with this truck just a daily. Can clutch material from the converter damage the trans? Would like to just replace converter if you think it's worth the gamble.
  5. B

    Lbz 6 speed transmission getting over 200

    Mike should I rebuild the Trans as well when I pull it? Located in Florida
  6. B

    Lbz 6 speed transmission getting over 200

    Codes po741 po762
  7. B

    Lbz 6 speed transmission getting over 200

    I bought an lbz recently the previous owner said the Trans would get hot after 30 mins of driving. I have put 500 miles on the truck and have not seen temps increasing till now. I drove it home today which is 10 miles and the temp read just above 200 as I pulled into the driveway, outside temp...
  8. B

    What was the issue with your Trans getting hot? I have the same issue you can text me if you...

    What was the issue with your Trans getting hot? I have the same issue you can text me if you want 321-961-6782 thanks
  9. B

    Crank shaft roll pins sheared off Reluctor wheel

    Yes it is call me 321-961-6782.
  10. B

    Crank shaft roll pins sheared off Reluctor wheel

    Here is my old gear machined down to drill new pin holes.
  11. B

    Crank shaft roll pins sheared off Reluctor wheel

    The tool we made to drill the pins worked, had to use a starter bit first then step up from there. Time to reassemble
  12. B

    Crank shaft roll pins sheared off Reluctor wheel

    Used my stud welder for autobody to pull the existing pins, if you ever have to do this it take a few heat cycles for the pin to pop out.
  13. B

    Crank shaft roll pins sheared off Reluctor wheel

    I'm working with a local machine shop using my old gear as a drill bit guide. Gonna run 2 pins for the balancer and 2 for the reluctor gear. I'll post pics
  14. B

    Crank shaft roll pins sheared off Reluctor wheel

    No was just using it as a pointer for someone
  15. B

    Crank shaft roll pins sheared off Reluctor wheel

    03 truck wouldn't start, figured out the reluctor was spinning freely on the crank by accessing it through the crank sensor hole. After removing the timing cover we could see the reluctor pin had sheared off, and the crank pulley pin is damaged as well. I found the empire crank kit for the...
Top Bottom