Search results

  1. N

    RR Door Ajar

    My daughter has a 2003 CCSB D/A that is loaded. It constantly has a message on the DIC RR Door ajar. Today I removed the lock assembly and checked the operation of the switch. It appears to work, but I am not sure of what pin does what. Unplugging the wiring harness had no effect on the door...
  2. N

    LML or LMM as foundation for new LB7

    I have found two sources for brand new engines, one is a complete long block LMM that Banks has for 6500.00, the other is a LML short block brand new on ebay for 5900.00. My LB7 still runs great at 260k, but I have been thinking about putting an engine together and having it ready to go when the...
  3. N

    Low Power High EGT's

    Last September my dad blew the engine in his 02 lb7. An injector stuck open and his hearing isn't very good and he kept driving it. I drove to Reno and picked up his truck and then on to Vegas and picked up a good deal on a reman engine with low miles. I got the truck home to Wyoming and pulled...
  4. N

    Weird TCC slip numbers

    Was doing some data logging yesterday looking for causes of dead pedal on my 02 in 4 low. Couldn't make it act up, go figure. I did see two readings that were way goofy. TCC would go from single digits to 82xx, did this in low range, high range tow haul or normal. Truck feels fine, I am...
  5. N

    Desired Torque

    While trying to determine cause of intermittent low range dead pedal, I found the desired torque reading on the scan tool way out of range. On several occasions desired torque read 48,xxx. After driving for a while, it came back to normal range of 180-250 lb ft. Where does this signal come...
  6. N

    Defueling/Dead pedal in 4 low

    Like the title says. My 2002 D/A defuels or sometimes has a dead pedal in 1st gear low range. Sometimes I can push the throttle to the floor and rpms won't increase at all and then the tranny will shift into second and everything will work fine. This seems to be most noticeable when I have 5er...
  7. N

    Low range dead pedal

    I am posting this here, because someone has had to run into this while pulling. Sometimes when in 4lo, I get a dead pedal. I can push the pedal all the way to the floor and the engine doesn't respond. Sometimes it happens when towing and sometimes just when crawling in 4 lo. Any thoughts?
  8. N

    Charging Issues

    Last week while on an adventure into the Big Horn Mountains of Wyoming with my trusty 02 Dmax towing my 11,500 5er with a 4 wheeler trailer tagging along, I hit a bad patch of snow/ice while climbing over a pass in the national forest and buried the truck in the snow, wishing I would have...
  9. N

    Soft 1-2 upshift

    Just kind of curious on your thoughts, when my tranny shifts from 1st to 2nd, there is a slight pause and then shifts, is this due to the edge and ppe both defueling? Edge is set on 4 and PPE on 5. Tranny has a full transgo with alto C-2's. This condition is mostly present in normal mode and is...
  10. N

    2006 communication problem

    Friend has an 06 duramax/allision totally stock and is having a problem thowing a tranmission code that says communication with ecm lost. I am thinking that maybe a pin in the harness isn't making good contact, but what would be the best place to start, back of tranny plug or at ecm? When I...
  11. N

    New transplant from wyoming

    BEEN LOOKING FOR A NEW HOME MAYBE I FOUND IT.:hello::hello: