''Remington Arms Co. makes the Bushmaster semi-automatic rifle that was used in the Connecticut shootings and again on Christmas Eve when the two firefighters were slain in Webster''
Thought 4 pistols were used at conneticut and the ar15 was left in the trunk?? Corrupt ass government
Hey guys im just curious who yall are using to ship engines? Ive called ups, act so far and was quoted $2k by ups wtf..and act only does full truck loads. Trying to buy a stock engine from a guy and this will help me when i go to ship my built motor to whoever buys it. Who do ya'll use and what...
I dont see it happening with what you have, unless it was on 4 slicks then maybe. I hit 11.99@113 on billet s366,60% over injectors, wicked stage 3 pump.
Just got my engine back from machine shop friday, got to buy the mandrel bent pipe tomorrow and finish fabbing the turbo setup. Should be driving it next weekend:woott:
im gonna run a boost gauge and see what each turbo is making, on my buddys cummins the 63 was making 45 and 80 was doin 30 which i thought was pretty good.. I was planning to spray it but i think that will be a bad idea with no gate.
Just curious if anyone else has done this? Im bout to build a 66/s480 setup when i get my built motor back from machine shop and didnt feel like trying to fab a wastegate in there. My buddys cummins ran a 63/s480 non gated and it drove awesome...went 11.3 @126mph. Anyone else done this on...
Im not sure i would put that much fuel to a stock turbo?? on my 60% overs and dual pumps i ran 11.71 @119 with the s475 batmo and egts got to 1700* about 6 runs later i had a nice hole in the stock piston. 2496pw 29.5* timing
Anyone know a part number to the harness that has oil pressure sensor, oil level sensor and i assume 4wd all connected to it? It connects to the main harness on top of the engine...think mine sagged down and hit the front drive shaft ripping it all out. I cant find this piece of the harness...